Using The Wall Mounting Assembly - THOMSON SpeedTouch 545 Setup And User Manual

7 Support

7.2 Using the Wall Mounting Assembly

Wall mounting
assembly
Preparing and using the
wall mounting assembly
76
Part of the package is a wall mounting assembly which allows you to conveniently mount
the SpeedTouch™ on a wall.
Before you start, check for the following items:
•
The wall mounting assembly (with Velcro sticker and counterpart sticker in place)
•
2 screws and 2 wall plugs
Proceed as follows:
Mark two hole horizontal positions, 134 mm (5.36 inches) apart:
1
Drill the marked holes with a 6mm (0.24 inches) diameter drill bit to a minimum
2
depth of 35mm (1.38 inches).
Insert the wall plugs in the drilled holes, position the wall fixing assembly over the
3
holes, insert the screws in the wall plugs and tighten them firmly:
Remove the covering sticker from the (counter) Velcro sticker.
4
Position the SpeedTouch™ over the two hooks:
5
Slide the SpeedTouch™ down into place and firmly press it to the assembly to
6
stick the counterpart Velcro sticker to the SpeedTouch™ housing.
E-DOC-CTC-20030814-0001 v1.0