Mounting Your Speedtouch - THOMSON SpeedTouch 585 Installation And Setup Manual

Chapter 2
Basic Installation
Setup possibilities
Wall mount
Stand-up
6

2.1 Mounting your SpeedTouch™

You can mount the SpeedTouch™ on a wall, set it up upright or simply place it on a
desk.
Proceed as follows to mount the SpeedTouch™ on a wall or other vertical surface:
1
Drill two holes in the wall or other vertical surface where you want to place the
SpeedTouch™.
2
Fasten two screws in the wall holes. The screws should protrude five
millimetres from the surface of the wall.
3
Attach your SpeedTouch™ on the wall using the two mounting slots on the
bottom.
If you install the SpeedTouch™ onto plasterboard, use dowels to
secure the screws. Otherwise the strain of the cables connected to the
SpeedTouch™ rear panel connectors could pull the SpeedTouch™
from the wall.
To set up the SpeedTouch™ in an upright position, use the cradle (if available).
*ACCESS CODE 0123456789* *DSLBSFFFFF RQQI*DSLBSFFFFF RQQI
MODEM ACCESS CODE: 0123456789
SpeedTouch ZZZ
*MACADDRESS AAABCCCDDEEE* *MACADDRESS AABCCCDDEEE*
SSID:SoeedTouchVVVVVV
MAC: AAABCCCDDEEE
WEP (hex):1234ABCDEF
! WPA PSK: 1234ABCDEF
TCM: 12345670
THOMSON TELECOM
DSLBSFFFFF RQQI
S/N:CPYYWWPPXXX (CC)
~
RATED INPUT: 18V
1000mA
E-DOC-CTC-20051017-0093 v1.0