Mounting Your Thomson Gateway - THOMSON ST516v6 Installation And Setup Manual

2.1

Mounting your Thomson Gateway

Setup possibilities
You can mount the Thomson Gateway on a wall or simply place it on a desk.
Wall mount
Proceed as follows to mount the Thomson Gateway on a wall or other vertical surface:
1 Drill two holes in the wall or other vertical surface where you want to place the Thomson Gateway.
2 Fasten two screws in the wall holes. The screws should protrude five millimetres from the surface of the
wall.
3 Attach your Thomson Gateway on the wall using the two mounting slots on the bottom.
i
If you install the Thomson Gateway onto plasterboard, use dowels to secure the screws.
Otherwise the strain of the cables connected to the Thomson Gateway rear panel connectors
could pull the Thomson Gateway from the wall.
6
*ACCESS CODE 0123456789* *DSLBSFFFFF RQQI*DSLBSFFFFF RQQI
MODEM ACCESS CODE: 0123456789
SpeedTouch ZZZ
*MACADDRESS AAABCCCDDEEE* *MACADDRESS AABCCCDDEEE*
SSID:SoeedTouchVVVVVV
MAC: AAABCCCDDEEE
WEP (hex):1234ABCDEF
WPA PSK: 1234ABCDEF
!
TCM: 12345670
THOMSON TELECOM
DSLBSFFFFF RQQI
S/N:CPYYWWPPXXX (CC)
~
RATED INPUT: 18V
1000mA
E-DOC-CTC-20060911-0017 v2.0
Chapter 2
Basic Installation