Appendix B: Troubleshooting
Restoring Factory Default Settings
Caution!
Web Browser
Note:
78
If required, you can restore the factory default settings to your StorPoint NAS.
This might be needed if you have disabled all the network protocols, or if you
have lost the Server password.
You can use any of these methods:
•
Web browser
•
FTP on a TCP/IP network
•
Push button
Step by step instructions for each method are given below.
The node address, the Hardware Address parameter, will remain
unchanged, but all other parameters will be restored. You will thus need to
re-assign the IP address in order to re-establish the Web browser
connection.
To restore the defaults settings using a Web browser:
1. Start the Web browser.
2. Enter the name or IP address of your StorPoint NAS in the location/address
field.
3. Click admin. You will be prompted for the Server password. By default, this
is set to
. To change the Server password, see "Server Password " on page 24.
pass
4. Click This StorPoint.
5. Click the Factory Defaults button at the bottom of the page.
6. Select the required factory default option:
Configurations - This option restores all server and network protocol
settings to their factory default values. Your Web browser will lose contact
with the server.
Volume Properties - This option will remove:
• Volume properties such as the volume names
• Access rights for the Root, System and Volumes folders. The access
rights for the hard disk volumes will remain unchanged.
• All the existing RAID pairs. As a result of this you will need to format
the hard disk volumes manually.
All - This option includes both the above actions.
If you select the Configurations or All option, you will need to re-assign the
IP address as described in "Assigning an IP Address " on page 12.
7. Click OK.
The factory default setting will now be restored and your StorPoint NAS will
then automatically restart.
AXIS StorPoint NAS 100 User's Manual