Axis NAS 100 User Manual page 38

Section 4: NetWare (NCP)
Note:
Deleting the Server
Object
38
5. Save the
config.ini
takes about 15 seconds, after which users will be able to access your StorPoint
NAS in NDS mode.
6. Check the
logfile.txt
successfully installed. See "Installation Errors in NetWare NDS" on page 39.
7. After the installation you must logout and then login again to have all the
necessary rights on the StorPoint NAS server object and the associated volume.
Using the NWAdmin, you will find a new server object and corresponding
volume object in the context you chose above.
StorPoint NAS installed in the NDS Tree
You can display Details in NWAdmin to verify the syntax of the


NDSServerContext
If using the partition manager within NWAdmin to delete the server object from
your NDS tree, you must turn off your StorPoint NAS and keep it turned off for
5 minutes before deleting the object. If you do not turn off the server before
attempting to delete the server object, your client workstation will hang and you
will have to reboot your PC. However, when using NDS manager this is not
needed.
file to start the NDS server installation. The installation
file to verify that your StorPoint NAS was
and parameters.
NDSAdminName
AXIS StorPoint NAS 100 User's Manual