Table of Contents
Advertisement
Section 4: NetWare (NCP)
Section 4
Network Settings
NetWare Server
Name
Recommendation!
Time Synchronization
Installation as an
NDS Server
34
NetWare (NCP)
This section outlines the required configuration settings for running your
StorPoint NAS in the Novell NetWare environment and how to set up access
restrictions.
StorPoint NAS supports a maximum of 1000 users in NetWare.
If you intend to use StorPoint NAS in a multiprotocol environment, proceed to
the other relevant sections in this manual, namely:
•
"Section 3 - Microsoft & IBM Networks (SMB)"
•
"Section 5 - UNIX (NFS)"
•
"Section 6 - FTP"
•
"Section 7 - Web Browser (HTTP)"
StorPoint NAS emulates both a 5.x NDS server and a NetWare 3.x bindery
server. It also supports NetWare/IP and PureIP. In NetWare 5 environments,
StorPoint NAS can be integrated as any other 5.0 server simultaneously accessed
via IPX, NetWare/IP and PureIP.
If your network supports TCP/IP, you can use the StorPoint NAS
Administration Web pages for configuration.
The default NetWare server name is AXIS<nnnnnn>_NW, where <nnnnnn>
are the last six digits of the StorPoint NAS serial number. This is the name that
will be presented to the NetWare clients on the network. You can change that
name by editing the NetWare Server Name parameter. It is useful to choose a
more descriptive name, e.g. in order to indicate where the unit is located.
Choose a more descriptive name for your server, e.g. NasServer.
Make sure you specify the time synchronization source properly. Refer to
"Date & Time" on page 25.
If used as an NDS server, your StorPoint NAS must first be installed in the NDS
tree. The most convenient way to do this is using the installation wizard
available from the StorPoint NAS Web interface, see "Wizard" on page 35.
However, if you do not have TCP/IP, you must use a text editor and edit the
configuration file manually. Refer to "Text Editor" on page 36.
AXIS StorPoint NAS 100 User's Manual
Advertisement
Table of Contents
