Axis NAS 100 User Manual page 79

FTP
Push Button
AXIS StorPoint NAS 100 User's Manual
To restore the default settings using FTP:
1. Log in to your StorPoint NAS with the command:
ftp <IP address>,
assigned to your StorPoint NAS.
2. You will be prompted for user id and password. Use the user id
has the default password
3. Restore the default setting with the command:
get defaults
The unit will then automatically restart.
4. Log out using any of the commands
FTP version.
To restore the default settings using the Push button:
1. Turn off your StorPoint NAS.
2. Press and hold the Push button using a thin object, e.g. a pen.
3. Restart your StorPoint NAS.
4. Wait until the Status indicator flashes yellow (one flash/second).
5. Let go of the button at least two seconds.
6. Press and hold the Push button again until the Status indicator shows a
steady yellow light. This may take 10 - 15 seconds.
7. Restart your StorPoint NAS. StorPoint NAS is now reset to factory default
settings.
where is the name or IP address
<IP address>
( is the user id with the highest priority).
pass root
,
quit bye
Push button
Appendix B: Troubleshooting
, which
root
or depending on your
exit
79