Table of Contents
Advertisement
Important!
Requirements
Notes:
Wizard
Important!
AXIS StorPoint NAS 100 User's Manual
If you change any of the following parameters after installing your StorPoint
NAS in the NDS tree, you might need to repeat the installation:
• IP address
• Internal Net Address
• IPX Enable
• PureIP Enable
When installing the first StorPoint NAS into the NDS tree, it is recommended
that you use an account with Supervisor rights to the [Root] of the tree. This
means that the user specified in the NDS Admin Name parameter must have
Supervisor access rights.
StorPoint NAS will extend the NDS Schema with a new attribute called
which will be added to the NDS Server object class. The
AXIS:SPcd:rights
extension is needed for storing configuration data. StorPoint NAS also becomes
easier to administrate and more fault tolerant to changes in your NDS tree.
The new attribute will not affect the operation of your NetWare servers.
Adding the schema extension requires Supervisor rights to the [Root] object
of the NDS directory tree.
If you do not have Supervisor rights to [Root] or if schema extensions are
not allowed in your NDS tree, you can store the access rights in a file on a
NetWare file server. However, you must specify the NDS Rights Storage
and NDS Rights File parameters properly. You will need Admin rights to
the Organizational Unit (OU). After the NDS installation, you must create
and assign access rights to the directory on the Novell file server where the
file is stored.
For subsequent installations, Create rights to the context where you want to
install StorPoint NAS will be sufficient.
The installation wizard is a convenient way to install your StorPoint NAS in the
NetWare environment.
1. Verify that the NDS tree is synchronized. To do that, you load
on a NetWare server console in the NDS tree and select
DSREPAIR.NLM
Unattended full repair
If the NDS tree is not synchronized, do not continue the installation until
you have solved the problem.
2. Start your Web browser, and enter the name or IP address of your StorPoint
NAS in the location/address field.
3. Click admin. You will be prompted for the user name and password. By
default, these are set to
"Server Password" on page 24.
4. Click Network Settings.
.
and
. To change the Server password, see
root
pass
Section 4: NetWare (NCP)
35
Advertisement
Table of Contents
