Axis NAS 100 User Manual page 99

Connecting the
IDE Drives
Note:
AXIS StorPoint NAS 100 User's Manual
To connect the IDE drives to StorPoint NAS, follow these steps:
1. Connect the IDE cable to the IDE connector on StorPoint NAS.
2. Connect the IDE cable to the drive(s).
3. Assign each of the connected drives to Master or Slave. Refer to the drive
documentation for instructions on how to set the device type for your drives.
The server must be physically located at one end of the cable.


4. Switch the power on to the whole of the tower.
5. The StorPoint NAS front panel indicators will flash during power-on and self-
test. When the Status indicator stops flashing and turns solid green, StorPoint
NAS is ready for use.
Appendix D: Tower and Drive Installation
99