Inserting Batteries In The Remote Control - Grundig MASQ RRCD 9100 PLL User Manual

POWER SUPPLY

Inserting batteries in the remote control

Open the battery compartment by pushing down the lid of the battery
1
compartment.
When inserting the batteries (micro type, for example AAA, R 3, UM4),
2
observe the polarity marked on the base of the battery compartment.
Note:
If the device no longer reacts properly to remote control commands, the
batteries may be flat. Always remove flat batteries. No liability is accep-
ted for damage resulting from leaking batteries.
Insert back-up batteries
During mains operation, the back-up batteries ensure that operation is not
interrupted and stored setting are not lost in the case of a power failure, or
when the device is disconnected from the mains for a short period.
Open the back-up battery compartment inside the battery compartment
1
by pressing the snap-catch and removing the lid.
When inserting the batteries (micro type, for example AA, R6, UM3),
2
observe the polarity marked on the base of the battery compartment.
_______________________________
29