Tuner Mode - Grundig MASQ RRCD 9100 PLL User Manual

FLAT
37 100.6
CH FM MHz
TUNER
FLAT
36 107.4
CH FM MHz
TUNER
FLAT
37 100.6
CH FM MHz
TUNER

TUNER MODE

Antennas
For FM stations (VHF) extend the telescopic antenna
1
Note:
If the FM signal is too strong, it is advisable to push in the telescopic
antenna.
The radio recorder has a built-in rod antenna for MW and LW reception.
2
Turn the radio recorder to point the antenna.
Selecting the tuner as the source
Select the input source using the »TUNER/BAND« button.
1
– The most recently selected station can be heard (Last Station Memory).
Selecting the preset position
Select desired waveband (FM, MW or LW) with
1
2 Select the station position step by step with
or with » 5a « and »
– Display: for example, »CH 36« and the frequency.
Stereo/mono reception
If the device is receiving an FM stereo station »
However, if the signal from the FM stereo station is weak, you can improve
the sound quality by switching to mono reception.
Press »FM MODE« on the remote control to switch to mono reception.
1
– Display: » « disappears.
To switch back to FM stereo press
2
– Display: » «.
– If the device is set to stereo reception and is receiving a mono signal,
the » « display flashes.
Automatic station search (ASP)
By starting the automatic station search, you can delete all the existing preset
stations and at the same time allocate new radio stations to them.
Start the automatic search in tuner mode by pressing and holding down
1
»PROGRAM/PROG.«.
– After the search has finished, the station stored in position 01 can be
heard.
Note:
The automatic station search can be interrupted with
PROG.«.
_______________________________________
»MEM
s 6 « on the remote control.
»FM MODE« on the remote control.
»ANTENNA
8
»TUNER/
BAND«.
« on the device
« appears in the display.
»PROGRAM/
«.
33