Order Of Installation - Lexmark X790 series User Manual

Additional printer setup
3
Remove the screws while holding the printer hard disk in place, and then remove the printer hard disk.
4
Set the printer hard disk aside.
5
Reattach the system board cover.

Order of installation

CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more
trained personnel to lift it safely.
CAUTION—TIPPING HAZARD: Floor-mounted configurations require additional furniture for stability. You must
use either a printer stand or printer base if you are using a high-capacity input tray, a duplex unit and an input
option, or more than one input option. If you purchased a multifunction printer (MFP) that scans, copies, and
faxes, you may need additional furniture. For more information, see www.lexmark.com/multifunctionprinters.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
Install the printer and any options you have purchased in the following order:
•
Caster base
•
Optional spacer
•
Optional 550‑sheet trays or 2,000‑sheet high‑capacity feeder
• Standard 550‑sheet trays
• Printer
For information on installing a caster base, a 550‑ or 2,000‑sheet optional tray, spacer, or any of the finishers, see the
setup documentation that came with the option.
1
2
44