Table of Contents
Advertisement
Water hardness
1)
in °d
in mmol/l
51 - 70
9,0 - 12,5
43 - 50
7,6 - 8,9
37 - 42
6,5 - 7,5
29 - 36
5,1 - 6,4
23 - 28
4,0 - 5,0
19 - 22
3,3 - 3,9
15 - 18
2,6 - 3,2
11 - 14
1,9 - 2,5
4 - 10
0,7 - 1,8
below 4
below 0.7
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
Adding special salt
To decalcify the water softener, it must be filled up
with special salt. Use only special salt suitable for
domestic dishwashers.
If you do not use 3 in1 detergent, fill up with special
salt:
– Before using the dishwasher for the first time.
– When the control indicator for special salt is illumi-
nated on the control panel.
1. Open the door and remove the lower basket.
2. Screw open the lid on the salt dispenser by turning
it anti-clockwise.
3. Only when using the dishwasher for the first
time:
Fill the salt dispenser with water.
4. Place the funnel (supplied) over the dispenser
opening.
Fill the dispenser with special salt; the capacity of
the dispenser is approx. 1.0-1.5 kg, depending on
the size of the grains. Do not overfill the dispenser.
3
If water overflows when filling up with special
salt, this is completely harmless.
5. Clean away any salt remnants from the dispenser
opening.
6. Screw the lid back on in a clockwise direction.
7. Run a dishwashing cycle after filling the salt
dispenser with special salt. This will wash away
salt water and salt crystals that have been spilt.
3
Depending on the size of the salt grains, it can
take several hours for the salt to dissolve in
the water and for the control indicator for spe-
cial salt to go out.
2)
Range
IV
III
II
I/II
I
Adjusting the hardness setting
Manual
Electronic
1
0*
no salt necessary
Number of
flashes
3)
10
10
9
9
8
8
7
7
6
6
5
5
4*
4
3
3
2
2
1
1
9
Hide quick links:
Advertisement
Table of Contents
