Hanging The Fan - Casablanca C31uxxB Owner's Manual

Step 4e. Slide the hanging adapter cover down over
the motor coupling as shown in Figure #6, making
sure that the adapter cover is covering the motor
coupling as in shown Figure #7.
Figure #6
Step 6a. To hang the fan body in the canopy, hold
the fan body firmly and insert the ball into the canopy
opening. Check that no wires are pinched. Rotate the
fan body until the slot in the ball fits into the pin opposite
the canopy opening.
Step 6b. Trim excess motor wires, leaving at least 6
inches above the downrod. Strip
the end of each wire using a wire stripper (available at
your local hardware store).
fan preparatIon - contInUed
HANGING
ADAPTER
COVER
MOTOR
COUPLING

HanGInG tHe fan

/ -inch insulation from
1
2
H
™
olliston
HANGING
ADAPTER COVER
Figure #7
BALL
SLOT
DC
CANOPY COVER
RING
PIN
11