Casablanca C31uxxB Owner's Manual page 17

Switch housing and Light kit
adaptor installation - Continued
Step 12e. Locate the bottom cap and screw as shown
in Figure #5, using the screw that you earlier removed
from the light kit adaptor assembly (see step 11c) and
insert cap screw through the hole in the center of the
cap and attaching the cap the bottom of the fan as
shown in Figure #5 on this page. Then tighten the
screw with the provided screwdriver.
Step 12f. Locate the end cap screw plug shown in
Figure #6, align and insert the two (2) holding tabs
located on the screw plug with the slots located in the
center of the end cap, then press on the plug locking
end cap screw plug into place also as shown in Figure
#6 and Figure #7.
end CaP
SCReW
Figure #6
PLuG
Switch housing and Light kit
adaptor installation
( no LiGht kit ) -
NOTE: .
t o . c ontinue . i nstallation . i nstruction, .
go . to . (Inteli-touch . 3 . - . control . Installation) .
within .this .document . .
( no LiGht kit)
Figure #5
PLuG
taBS
end CaP
Figure #7
end
Figure #8
H
™
olliston
BottoM
CaP
CaP SCReW
#6-32
SCReW
PLuG
DC
17