Casablanca C31uxxB Owner's Manual page 19

Switch housing and Light kit
adaptor installation:
Step 14a. Locate and remove the three (3) #8-32
screws from the center shaft adapter located on the
bottom of the fan as shown in Figure #6.
Step 14b. Locate the light kit adaptor plate as shown
in Figure #7 and thread BLUE and WHITE wires
through the hole in the center of the light kit adaptor
plate, also as shown in Figure #7.
Step 14c. Locate the three (3) screws that you
removed from the center shaft adapter during Step
14a, these three screws are needed to attached the
light kit adaptor plate to the fan. Align the screw hole
on the light kit adaptor plate with the screw holes on
the center shaft adaptor and insert all three (3) screws
as shown in Figure #8. Then tighten all three screws
with the provided screwdriver.
Step 14d. Locate the light kit adaptor plate cap as
shown in Figure #9 and thread BLUE and WHITE
wires through the hole in the center of the light kit
cap, also as shown in Figure #9
- Continued
( LiGht kit)
H
olliston
CenteR ShaFt
adaPteR
adaPteR SCReWS,
#8-32
(Screws 3)
Figure #6
LiGht kit
adaPtoR
PLate
White
WiRe
Figure #7
CenteR ShaFt
adaPteR
LiGht kit
adaPtoR
PLate
SCReWS , #8-32
(Screws 3)
Figure #8
CaP
White
WiRe
BLue
WiRe
Figure #9
DC
™
BLue
WiRe
19