Table of Contents
Advertisement
Call timer
Here you can switch the unit's call timer during a call on or off.
1. Press
.
}
2. Scroll
/
{
}
3. Scroll
/
{
}
4. Scroll
/
{
}
Reset handset defaults
An individual handset can be reset to the original factory default condition
resulting in loss of memories and all programmed settings, other registered
handsets will not be affected.
1. Press
.
}
2. Scroll
/
{
}
3. Scroll
/
{
}
4. Enter the current PIN number (0000 when supplied).
5. Press OK again to confirm.
Registering a new handset
To enable the use of more than one handset a registration has to be performed.
Every new handset must be registered in order to use the current base unit, each
base unit can handle up to 4 handsets.
On registration the handset is allocated a handset number for use on the new
base unit, the handset numbers are 1-4.
Additional handsets can be purchased from your local retailer. Please refer to
the Expanded Systems chapter for more information.
1. Press and hold the button on the base unit until it beeps. Registration mode
will remain active for approximately 60 seconds.
2. Press
.
}
3. Scroll
/
{
}
4. Scroll
/
{
}
5. When ENTER PIN is displayed, enter the units PIN number (0000 when
supplied). Press OK.
6. If the registration is successful the handset will emit a happy tone in a few
seconds (max 60 secs).
www.doro.com
Handset settings
to HANDSET. Press OK.
to CALL TIMER. Press OK.
to either ON or OFF. Press OK to save.
to HANDSET. Press OK.
to DEFAULT. Press OK.
to HANDSET. Press OK.
to REGISTER. Press OK.
English
1
Advertisement
Table of Contents
