Ducati SUPERBIKE 1098 R BAYLISS Owner's Manual page 58

To adjust the position of the rear brake pedal, proceed as
6 7
follows:
E
Loosen the locknut (4).
Turn the pedal travel adjustment bolt (5) until the pedal is in
the desired position.
Tighten the locknut (4) to a torque of 2.3 Nm.
Operate the pedal by hand to check that there is 1.5 to 2 mm
of freeplay before the brake bites.
If not, adjust the length of the master cylinder pushrod as
follows:
Slacken off the locknut (6) on the pushrod.
Screw the rod into the clevis (7) to increase play, or unscrew
it to reduce play.
4
Tighten the lock nut (6) to a torque of 7.5 Nm and re-check
the free play.
5
fig. 41
57