Adjusting The Position Of The Gearchange And Rear Brake Pedals - Ducati MONSTER 695 Use And Maintenance Manual

Adjusting the position of the gearchange
and rear brake pedals
The position of the gearchange and rear brake pedals in
relation to the footrests can be adjusted to suit the
requirements of the rider.
To adjust the position, proceed as follows:
Restrain the tie-rod (1) and slacken the locknuts (2) and (3).
Notes
The locknut (2) has a left-hand thread.
Rotate the tie-rod (1) using an open-ended wrench on the
flats (A) to move the gearchange pedal to the required
position.
Tighten the two lock nuts onto the tie-rod.
To adjust the position of the rear brake pedal, proceed as
follows:
Loosen the locknut (4).
Turn the pedal travel adjustment bolt (5) until the pedal is in
the desired position.
Tighten the locknut (4).
Operate the pedal by hand to check that there is 1.5 - 2 mm
of freeplay before the brake bites.
If not, adjust the length of brake master cylinder pushrod as
follows:
Slacken off the locknut (6) on the pushrod.
Screw the rod into the clevis (7) to increase play, or unscrew
it to reduce play.
Tighten the locknut (6) and recheck the pedal freeplay.
3
5
1
2
fig. 17
6
7
4
fig. 18
27
E