Table of Contents
Advertisement
Instrument panel
(fig. 4)
1) LCD, (see page 13).
2) Tachometer (rpm).
Indicates engine revs per minute.
3) Neutral (N) indicator (green).
Illuminates when the gearbox is in neutral.
4) Fuel warning light
Illuminates when there are about 3 litres of fuel left in the
tank.
5) Turn signal indicator light
Illuminates and flashes when the turn signal is in operation.
6) Engine oil pressure warning light
Illuminates when engine oil pressure is too low. This light
should illuminate when the ignition is switched to ON and
should go out a few seconds after the engine starts.
It may come on briefly if the engine is very hot, but should
go out again as engine speed increases.
Important
If this light (6) stays on, stop the engine to avoid
serious damage.
7) High beam warning light
Illuminates when the high beam headlight is on.
8) "Engine diagnostics light"
The engine control unit turns on this light permanently to
indicate an error leading to engine block.
(yellow).
(green).
(red).
(blue).
(amber ambra).
2
5
9
8
6
9) "Motorcycle diagnostics" light.
Illuminates when the motorcycle diagnostics detects a
problem.
10) Rev limiter indicator lights
Indicator light 10A: illuminates steadily at 800 rpm before
intervention of the rev limiter.
Indicator light 10A on steadily + 10B: illuminate steadily
400 rpm before intervention of the rev limiter.
Indicator light 10A + 10B flashing + 10C: start flashing when
the rev limiter is reached.
10A
10B
10C
3
4
7
5
1
E
fig. 4
11
Advertisement
Table of Contents
