USB DAQ
This function activates the USB Data Acquisition (DAQ)
(see page 66): the DAQ must be connected to the
motorcycle wiring.
To activate the DAQ, go into the menu and set the USB DAQ
to "On" by holding button (1, fig. 8) in position B "▼" for
3 seconds.
START and STOP the lap separator by pressing the high
E
beam FLASH button (12, fig. 5) on the left-hand handlebar
switch.
If the USB function is active and the display is suddenly
switched off (Key-Off), the function is switched off
automatically.
fig. 21
27