Engine Oil Maintenance; Engine Oil Specification; Checking Engine Oil - Wh1000I - Westinghouse WH2000i Series Owner's Manual

EnginE oil MaintEnanCE

Engine Oil Specification

1. Only use the engine oil specified in Figure 32.
2. Only use 4-stroke/cycle engine oil. NEVER
USE 2-STROKE/CYCLE OIL. Synthetic oil is an
acceptable substitute for conventional oil.
0°C
SAE 5W-30 SAE 10W-30
A
32°F
Figure 32 – Recommended Oil
Checking Engine Oil – WH1000i
NOTICE
Always maintain proper engine oil level. Failure to
maintain proper engine oil level could result in severe
damage to the engine and/or shorten the life of the
engine.
Always use the specified engine oil. Failure to use the
specified engine oil can cause accelerated wear
and/or shorten the life of the engine.
Engine oil level should be checked before every use.
1. Always operate or maintain the inverter on a flat
surface.
2. Stop engine if running.
3. Let engine sit and cool for several minutes (allow
crankcase pressure to equalize).
4. Remove the engine service panel to access the oil
fill/drain plug.
5. With a damp rag, clean around the oil fill/drain plug.
6. Remove the oil fill/drain plug (see Figure 33).
25°C
SAE 15W-40
C
B
80°F
MAINTENANCE
Figure 33 – Oil Fill/Drain Plug
NOTICE
Engine oil must always be checked and added when
the inverter is on a flat, level surface, or an inaccurate
reading may result, causing serious engine damage.
7. Check oil level:
When checking the engine oil, remove the oil fill/
drain plug.
• The oil level is acceptable if oil is visible at the
bottom of the threads of the oil fill plug.
• If oil level is low, add to the correct level using
the supplied oil fill bottle. Do not overfill the oil
crankcase.
Figure 34 – Checking Oil Level
33