Wh2000I Series; Spark Plug Maintenance - Westinghouse WH2000i Series Owner's Manual

WH20001 Series
1. Remove the engine service panel to access the
float bowl drain.
Figure 46 – Engine Service Panel
2. Locate the clear plastic hose from the float that is
exiting out the bottom of the inverter, and place a
suitable container under it to catch the drained fuel.
3. Loosen the float bowl drain screw until fuel is seen
draining from the float bowl (see Figure 47).
Figure 47 – Float Bowl Drain Screw
MAINTENANCE
4. Allow fuel to drain into the container, and then
tighten the float bowl drain screw.
NOTICE
Never dispose of fuel by dumping fuel into a sewer,
on the ground, or into groundwater or waterways.
Always be environmentally responsible. Follow the
guidelines of the EPA or other governmental agencies
for proper disposal of hazardous materials. Consult
local authorities or reclamation facility.
5. Install the engine service panel.

sParK Plug MaintEnanCE

The spark plug must be checked and cleaned after
every 100 hours of use or 6 months and must be
replaced after 300 hours of use or every year.
1. Stop the inverter and let it cool for several minutes
if running.
2. Move the inverter to a flat, level surface.
3. Slide the spark plug access cover off the housing
(see Figure 48).
Figure 48 – Spark Plug Access Cover
(WH1000i Shown)
4. Remove the spark plug boot by firmly pulling the
plastic spark plug boot handle directly away from
the engine (see Figure 49).
39