Right-Hand Side Panel - Planet IVS-H125 User Manual

2.2. Right-hand side Panel

IVS-H125
5V DC IN
(IVS-H125 only)
12V DC Out
(IVS-H125P only)
A/V Out
MIC in
Reset
The input power is 5V DC.
Note: ONLY use package power adapter supplied with the product.
Otherwise, the product may be damaged.
The IVS-H125P provides 12V DC out through power jack to analog camera.
The max output is DC 12V / 400mA.
Audio/Video-out Jack allows this device to output audio and video signal.
Use the attached A/V cable to connect A/V device where white cable is for
audio and yellow cable is for video.
Note:
1. The white jack is used for audio output, and yellow jack is used for video
output.
2. The IVS-H125 and IVS-H125P could determine the monitor use NTSC
or PAL format signal, and output the fitting video format to monitor
automatically. Please connect the video jack (yellow) with monitor
properly before power on the Video Server.
Connect an external microphone to the Video Server.
This button is hidden in the pinhole. This button is used to restore the all
factory default settings. Sometimes restarting the Video Server will make
the system back to a normal state. If the system still got problems after
restart, user can restore the factory default settings and install it again. To
restore the device, please follow the steps below:
a. Insert the paper clip or any proper tool and press and hold
the button down continuously.
b. Hold it at least 5 seconds and release the tool. Then the device
has been restored to default settings and reboot again.
Note: Restoring the factory default setting will lose the all previous settings
included IP address forever. User needs to run the PLANET IP Wizard II
program to search the device and configure it to let the device work properly
13
User's Manual of IVS-H125 Series
IVS-H125P