Ptz Setting - Planet IVS-H125 User Manual

6.2.5. PTZ Setting

This page allow user to modify the RS-485 interface according to the P/T scanner.
Camera Protocol
Camera Address
Baud rate
OSD Control
OSD Open
OSD Close
OSD Select
This device can connect to a PTZ camera or speed dome camera and
controls them thru RS-485 interface.
This is the camera ID set in PTZ camera or speed dome camera.
Note that please DO NOT changes the default value if unnecessary.
If so, user needs to check and set value properly for both sides.
If need to change these parameters, user needs to check and set
value properly for both, network module and P/T scanner.
Note that please DO NOT changes the default value if unnecessary.
If so, user needs to check and set value properly for both sides.
Choose the corresponding model for OSD control
Control commands for Open function.
Control commands for Close function.
Control commands for Select function.
51
User's Manual of IVS-H125 Series