The Left Handrail, Remove And Discard It - Pro-Form 730 Zlt Treadmill Manual
Uk manual
Hide thumbs
Also See for 730 Zlt Treadmill:
- Gebruikershandleiding (32 pages) ,
- Manuel de l'utilisateur (32 pages) ,
- Bedienungsanleitung (32 pages)
Table of Contents
Advertisement
5. Identify the Left and Right Base Covers (73, 74).
Slide the Left and Right Base Covers onto the
Left and Right Uprights (75, 76) as shown.
6. Identify the Left Handrail (71). If there is a wire in
the Left Handrail, remove and discard it.
Hold the Left Handrail (71) near the Left Upright
(75). Insert the wire tie on the Upright Wire (70)
through the bottom and pull it out of the end
of the Left Handrail as shown. Then, pull the
Upright Wire through the Left Handrail.
Attach the Left Handrail (71) to the Left Upright
(75) with two 3/8" x 3 1/2" Screws (9) and two
3/8" Star Washers (5). Make sure not to pinch
the Upright Wire (70). Start both Screws, but
do not tighten them yet.
5
75
73
6
70
Wire
Tie
9
76
74
9
5
71
75
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 730 Zlt Treadmill and is the answer not in the manual?
Questions and answers
When the device is turned on, it starts in tilt mode (incline) and does not stop when you press any button.
The Pro-Form 730 Zlt Treadmill may start in tilt mode and not respond to button presses because the incline system needs to be recalibrated. To recalibrate, hold down the Stop and Speed increase buttons, insert the key into the console, then release the buttons. Press the Priority Display button, then press the Incline increase or decrease button. The treadmill should move to the maximum incline and then return to minimum. If it does not start, press Stop and try again.
This answer is automatically generated