Pro-Form 730 Zlt Treadmill Manual page 8
Uk manual
Hide thumbs
Also See for 730 Zlt Treadmill:
- Gebruikershandleiding (32 pages) ,
- Manuel de l'utilisateur (32 pages) ,
- Bedienungsanleitung (32 pages)
Table of Contents
Advertisement
3. Identify the Left Upright (75). Have a second
person hold the Left Upright near the Base (80).
See the inset drawing. Tie the wire tie in the
Left Upright (75) securely around the end of the
Upright Wire (70). Then, insert the Upright Wire
into the lower end of the Left Upright as you pull
the other end of the wire tie through the Left
Upright.
4. With the help of a second person, hold the Left
Upright (75) against the Base (80). Be careful
not to pinch the wires.
Partially tighten three 3/8" x 4" Screws (4) with
three 3/8" Star Washers (5) into the Left Upright
(75) and the Base (80); do not fully tighten the
Screws yet.
Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the right
side.
3
70
Wire
Tie
75
4
5
4
8
75
70
80
75
Wires
80
Wire
Tie
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 730 Zlt Treadmill and is the answer not in the manual?
Questions and answers
When the device is turned on, it starts in tilt mode (incline) and does not stop when you press any button.
The Pro-Form 730 Zlt Treadmill may start in tilt mode and not respond to button presses because the incline system needs to be recalibrated. To recalibrate, hold down the Stop and Speed increase buttons, insert the key into the console, then release the buttons. Press the Priority Display button, then press the Incline increase or decrease button. The treadmill should move to the maximum incline and then return to minimum. If it does not start, press Stop and try again.
This answer is automatically generated