Part Identification Chart - Pro-Form 730 Zlt Treadmill Manual
Uk manual
Hide thumbs
Also See for 730 Zlt Treadmill:
- Gebruikershandleiding (32 pages) ,
- Manuel de l'utilisateur (32 pages) ,
- Bedienungsanleitung (32 pages)
Table of Contents
Advertisement
PART IDENTIFICATION CHART
Use the drawings below to identify small parts used for assembly. The number in parentheses below each draw-
ing is the key number of the part, from the PART LIST near the end of this manual. The number following the key
number is the quantity used for assembly. Note: If a part is not in the hardware kit, check to see if it is pre-
attached. Extra parts may be included.
#8 x 3/4" Screw
(6)––12
5/16" Star
3/8" Star
3/8" Nut (3)––2
M8 Nut (90)––2
Washer (8)––2
Washer (5)––10
1/4" x 1"
5/16" x 1"
1/4" x 1 3/4"
Screw (10)––4
Screw (7)––2
Screw (97)––2
M8 x 45mm
M8 x 50mm
Bolt (12)––1
Bolt (104)––1
3/8" x 2 1/2" Bolt (2)–– 2
3/8" x 3 1/2" Screw (9)––4
3/8" x 4" Screw (4)––6
6
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 730 Zlt Treadmill and is the answer not in the manual?
Questions and answers
When the device is turned on, it starts in tilt mode (incline) and does not stop when you press any button.
The Pro-Form 730 Zlt Treadmill may start in tilt mode and not respond to button presses because the incline system needs to be recalibrated. To recalibrate, hold down the Stop and Speed increase buttons, insert the key into the console, then release the buttons. Press the Priority Display button, then press the Incline increase or decrease button. The treadmill should move to the maximum incline and then return to minimum. If it does not start, press Stop and try again.
This answer is automatically generated