Important Information; What You Really Have To Read; Traffic Safety; Operating The Car Radio With An Automatic Antenna - Blaupunkt LONDON RDM 104 Operating Instructions Manual

Important information

What you really have to read

Before you operate your new car radio, plea-
se read the following information carefully.

Traffic safety

As the driver of a motor vehicle, it is your
responsibility to pay attention to the traffic
situation at all times. Never use your car radio
in a way that could distract you.
Please keep in mind that you travel a di-
stance of 14 m per second at a speed of only
50 km/h.
Should the traffic situation become particu-
larly demanding, we advise you not to use the
radio.
Always make sure that you are still able to
hear any warning signals coming from outsi-
de of the vehicle, such as police or fire engine
sirens, so that you can react accordingly.
Always select a moderate volume for playing
your car radio while you are driving.
30
Operating the car radio with an
automatic antenna
If you drive through a car wash, then the
automatic antenna must be fully retracted.
Switch the car radio off in order to ensure this.
If TIM ON appears in the display when you
switch the car radio off, then this means that
the timer is activated. The automatic antenna
will remain telescoped out for 3 hours.
In addition to this, the radio remains in the
standby mode for 1.5 hours before and after
the preset time when the timer has been
activated. In this case, the automatic anten-
na will also telescope out.
Press the TIM button briefly after you have
switched the radio off.
STBY OFF will then appear in the display and
the antenna will retract automatically.
After you have driven through the car wash,
switch the radio on again and the TIMER will
be reset.

Installation/Connection

If you would like to install this equipment
yourself or add any new components, then
please read the enclosed installation and
connection instructions carefully.
Optical display as theft protec-
tion
When you have parked your vehicle, you can
let the tongue of the KeyCard flash in order to
act as theft protection. Use DSC to select one
of two settings: LED ON or LED OFF. Please
read the section on "Programming with DSC
- LED ON/OFF".

KeyCard

The car radio can only be operated using
either KeyCard 1 or 2. Their codes are stored
in the unit.
Switch the unit on and insert the KeyCard
completely into the slot. The car radio is now
ready for operation. If the wrong KeyCard is
inserted, then "----" will appear in the display.
After approximately 10 seconds, CARD ERR
will appear in the display.
Do not make any further adjustments to the
radio until you have inserted the correct Key-
Card.
Never pull the KeyCard out directly.
First press the KeyCard in. This releases the
KeyCard and puts it in the proper position for
being removed. Now you can pull it out.
Should the KeyCard be lost or damaged,
then you must apply for a new KeyCard at an
authorized service centre. Designer Key-