Tim Standby Recording; Retrieving Stored Traffic Announce- Ments; Deactivating Tim; Switching Off The Tim Standby Recording Function Completely - Blaupunkt LONDON RDM 104 Operating Instructions Manual

In order to set the minutes
• press the rocker switch >>.
Set the desired minutes
• by pressing the rocker switch
In order to store the new time set (TIM TIME)
• press the -dB or the DSC button.
The TIM time is exactly in the middle of a 3-
hour recording period.
For example: TIM time is set at 7.30 h
Start TIM-TIME
6:00 7:30
TIM aktiv

TIM standby recording

TIM is activated.
After the radio has been switched off, TIM
remains in standby mode for 3 hours.
In addition to this, TIM is active for 1.5 hours
before and after the TIM TIME selected.
When TIM has been activated, then TIM-ON
will appear in the display briefly when the
radio is switched on.
40
Retrieving stored traffic an-
nouncements
• Press the TIM button briefly.
/ .
The following, for example, could appear in
the display: T1 7.30, i. e. T1 = traffic an-
nouncement 1, which was recorded at 7.30.
If four traffic announcements have been re-
corded, then T4 is always the most recent
one and will be played first.
During the traffic announcement you can
Ende
perform the following functions with the rok-
ker switch 6:
9:00
<<: back to the beginning of the message
: switch to the preceding message
: switch to the following message
>>: switch back to either radio or CD
playback
In order to cue or review during a traffic
announcement
• hold the rocker switch
down.
If no traffic announcements have been recor-
ded, then NO TIM will appear in the display
when you press the TIM button.

Deactivating TIM

After switching off the radio, you can also
deactivate the TIM mode until the next time
the radio is switched on by pressing the TIM
button. The radio will confirm that this
function has been deactivated by displaying
the message STBY OFF. The timer standby
will not be affected by this.
Switching off the TIM standby
recording function completely
In order to switch off the standby recording
• press the DSC button.
• Use the rocker switch
the menu TIM TIME.
• Press the -dB button and set the time
setting to TIM OFF with the help of the
rocker switch
TIM OFF is located between 23.00 and 0.00
h.
In order to store these changes and leave the
TIM MODE
• press the -dB or DSC button.
/ pressed
Notes
If you do not plan to drive your vehicle for an
extended period of time (for example, during
your holidays), then switch TIM off complete-
ly.
Please read "Important information" and the
section dealing with "Operating the car radio
with an automatic antenna" before you drive
through a car wash.
/ to select
/ .