Table of contents Switching between the memory levels Switching off the TIM standby Short description ......27 (FM) ............35 recording function completely ....40 Important information ....30 Storing stations ........35 CD playback ........41 Automatically storing the strongest What you really have to read ....
Short description 1 and 2 4 M?L (M - AM, L - Longwave) AUD mode: Tone: Selects the AM or longwave frequency << bass -, >> bass + range. Balance: Switch between AM and LW by pres- << left, >> right sing the button as often as necessary.
Page 5
8 Inserting the KeyCard : TPM button (Track Program Memory) DSC mode: Selects the DSC Insert the KeyCard into the slot with its Stores selected tracks from a CD. functions contact surface facing up. Tracks from up to 30 CDs can be Release the KeyCard by pressing it in stored.
Page 6
= AF button (Alternative Frequency for A CD insert C AUD button RDS) After a CD has been inserted, then the Press the button for longer than 2 se- With the help of AF the radio is able to playback will switch automatically from conds in order to switch the loudness automatically look for a frequency with the radio to the CD mode.
Important information What you really have to read Operating the car radio with an Optical display as theft protec- automatic antenna tion Before you operate your new car radio, plea- se read the following information carefully. If you drive through a car wash, then the When you have parked your vehicle, you can automatic antenna must be fully retracted.
Amplifier Cards are also available at a slightly higher Replacing the KeyCard Switching on/off price. The service centres are marked ( ) in A KeyCard can only be replaced by a new To switch the radio on: the car radio service centre list. one with the same number (1 or 2).
The radio will switch on and after one hour it In order to alter the MUTE value (display Adjusting the balance and fader will switch off again automatically. MUTE), You can alter the volume relationship bet- You can switch the radio on again for one •...
Adjusting bass and treble Setting the clock Adjusting the loudness In order to activate the bass and treble set- This radio is also equipped with a clock which It is more difficult for the human ear to detect tings you can have displayed during radio or CD bass sounds at low volume than to hear mid- playback.
Operating the radio with RDS (Radio Data System) The Radio Data System offers you more While the radio is looking for the strongest If you leave this regional program’s reception convenience when listening to the radio. reception signal, it will switch to mute briefly. area or you would like to take advantage of More and more radio stations have begun to When SEARCH appears in the display after...
Selecting stations automatically If you hold the rocker switch pressed down, The stereo symbol will light up in the then the frequencies will change quickly. display for stereo playback. Switching to the following station When you have reached the frequency you When you switch the radio on, stereo play- •...
• Select a station with the rocker switch been completed, the radio will tune in the The station button number and, for FM the (automatically with or manually strongest station. memory level, will flash in the display. with <</>>). Stations can also be stored manually in Tra- Depending on which memory level has been velstore if desired.
If you would like to listen to the station cur- PTY and station search which are stored under PTY SET in the DSC rently being scanned, mode. • Select, for example, SPORT on station If you would like to re-program the station •...
Receiving traffic information stations with RDS-EON Many FM stations regularly transmit current Traffic announcement priority • Use the rocker switch <</>> to set the reports on the traffic conditions in their broad- desired value from T1 to T9. While listening to the radio or to the CD casting area.
(Traffic Information Memo) If no traffic information station is found within You have the choice between the capital This car radio is equipped with a digital lan- 30 seconds of the start of the search function, letters A to Z, special characters and the guage memory which can record up to four then the CD playback will stop and you will digits 0 to 9.
In order to set the minutes Retrieving stored traffic an- button. The radio will confirm that this function has been deactivated by displaying • press the rocker switch >>. nouncements the message STBY OFF. The timer standby Set the desired minutes •...
CD playback Inserting a CD If you would like to play one of the following If a CD is inserted from which no tracks have tracks been stored in TPM, then NO-TPM will ap- • Switch the radio on. pear briefly in the display. All of the tracks on •...
Deleting TPM – Deleting the entire TPM READY and then CD UPD will then appear in the display. Using the lo/CLR (clear) button, you can • Insert a CD. In order to exit the DSC mode delete single tracks, all of the tracks for one •...
Switching sound sources with MIX playback 8 dashes will then appear in the display. The first dash will flash. When the function MIX has been activated, • Select the first character with the help then the tracks on a CD will be played in You can switch between the different sound of the rocker switch random order.
Programming with DSC The following DSC settings are available: Selecting the night bright- Using DSC (Direct Software Control), you ness: can adjust certain settings and functions for TIME: Use <<to set the hours, Switch the dashboard illu- this car radio to your own liking and then store >>...
Page 22
LOUDNESS: This function amplifies the SCANTIME: Use this function to set the TA LEVEL: With this function you can soft bass sounds to make scan time for the radio or set the volume for traffic them audible to the human CD player from between 5 announcements from bet- ear.
CD changer (optional) CD UPD: Use this function to update Overview of the DSC factory You can operate the Blaupunkt changers the TPM of your CDs. The CDC-A03/-F03 and CDC A05/-F05 by remo- settings information on all of the te control in combination with this car radio.
Selecting tracks MIX playback Proceed as described above in order to store other tracks. In order to select a track You can play either all of the tracks of one CD (MIX CD) or all of the tracks of all of the CDs •...
Appendix Deleting TPM for all of the CDs in the Naming CDs in the magazine Technical data magazine You can give each of the CDs in the magazi- Amplifier: • Press the lo/CLR button repeatedly ne a name which will then appear in the Output until CLR MAG appears in the display.