Sequence - Planet ICa-H612 User Manual

NOTE: The room ratio of an Auto Pan's Start Point will persist throughout the whole path.
Enter the speed ratio into the Speed field; the speed ratio ranges from 0 (low) to 3 (fast). Then choose
to run the Auto Pan Path in right/left direction from the Direction drop-down list.
Move the camera to another desired position as the end point of the Auto Pan Path. Click the "Set"
button of the "End Point" for saving the setting.
Auto Pan Run
Select the specified Auto Pan Path from the drop-down list, press the "Run" button, and then the
camera will start moving horizontally as recorded.
To view the camera panning in full screen mode, please move the cursor onto the live view pane,
right-click and left-click to select "fullscreen". Then users can view the camera navigation in full screen.
To stop running an Auto Pan Path, simply move the cursor to the live view pane and move the camera
in any direction.

4.5.4 Sequence

The Speed Dome IP Camera supports totally eight Sequence Lines; each Sequence Line consists of
up to 64 Preset Points. Please refer to the instructions below to program a Sequence Line.
NOTE: Before setting this function, users must pre-define at least two Preset Points.
Sequence Setting
Please press the "Edit" button in "Sequence Setting" section to enter the Sequence setting menu as
- 62 -