Related Manuals for Planet ICA-HM620
Summary of Contents for Planet ICA-HM620
- Page 1 PoE Plus Speed Dome IP Camera ICA-HM620 / ICA-H652 Quick Installation Guide...
- Page 2 Table of Contents Verify the Contents Inside the Package Box ............3 Physical Installation ..................4 Further Configuration ..................12...
- Page 3 Verify the Contents Inside the Package Box The package should contain the items below. If any item is missing or damaged, please contact the seller immediately. Dome Camera with Dome Compact Pendent Mount Outdoor Mount Kit Cover Waterproof Rubber Terminal Block Bracket Screw Kit Security Tool Lubricant...
-
Page 4: Physical Installation
Physical Installation 1. Please take necessary precautions when installing the hardware to avoid damage to the device and injury to the installer. 2. Please make sure the hardware is fastened on the wall properly to avoid unnecessary accidents. Double-check the hardware again after the installation. Caution 3. - Page 5 Step 3 Attach the dome cover to the camera body. Before doing that, apply some lubricant to the cover’s water-proof rubber to make the installation process smoother. The tiny protrusion on the dome cover must align with one of the four holes on the dome body.
- Page 6 Step 5 Use the M3 screw to screw the dome cover and camera body together. Step 6 Make a cable entry hole on the wall to recess the cables. Otherwise, users could push up the Cable Entry Board on the Compact Pendent Mount’s Mounting Plate to place the cables, as shown in the photo on the right.
- Page 7 Step 8 Pass the network and power cable through the Compact Pendent Mount 1. The network cable is not in the package. 2. Please block the cable entry hole with the supplied sponge to avoid insects entering the Pendent Mount. The sponge can be Note placed in two ways as shown in the illustrations below.
- Page 8 Step 9 Thread the cables through the Outdoor Mount Kit and join the Outdoor Mount Kit to the Compact Pendent Mount with the supplied screws and washers. Then adjust the Waterproof Rubber to the joint. Step 10 Connect power wires of AC adapter with Power Input connector of data cable. Please check the color of power wire carefully, and screw that with connector properly.
- Page 9 Step 11 Use the safety hook to hang the camera, and connect the cables to the Dome Camera. ...
- Page 10 Step 12 Assemble the Dome Camera to the Outdoor Mount Kit with the supplied M5 screw and washers. Rotate the dome camera until the two screw holes match the dome camera with the outdoor mount kit. Note Step 13 The adapter with the power cord attached is connected to a power outlet where the power voltage matches.
- Page 11 User PC Speed Dome (192.168.0.X) 1. For ICA-HM620, if there is a need to operate the Heater, please plug the AC 24V cable into the Camera’s Power Connector to power up the Camera instead. Heater can only be powered by the 24VAC adapter.
- Page 12 For the detailed configuration, please check user’s manual on the bundled CD. If you have any other question, please contact the dealer where you purchased this product or you can contact PLANET directly at the following email: Email address: support@planet.com.tw...