Table of Contents
Advertisement
The plinth area that can still be seen after the
hinged door has been installed can either be hid-
den with a matching panel, or by extending the
panel of the kitchen unit that is under the ap-
pliance.
Fitting the hinged door
Fit the two lateral bars A as shown in
1.
the figure opposite. Align bars at the
top so that the upper hole lies over the
pre-mounted aligning disk. With a
width of 568 mm first fix the addition-
ally supplied aligning disks B on the al-
ready pre-mounted aligning disks.
2.
Screw in the bars at the top only.
3.
Stand the machine in front of the
kitchen unit into which it is to be in-
stalled. Place cable and hoses into the
neighbouring unit.
As you push the machine in, keep on
pulling the cable and hoses through
and ensure that they do not become
kinked.
4.
Align the machine laterally in the
plinth area with the angle AN, tighten
the screw V slightly.
Fitting the hinged door
31
Advertisement
Table of Contents
