• The electrical cable for the safety valve is in the double-walled water inlet hose. Do not
immerse the water inlet hose or the safety valve in water.
• If water inlet hose or the safety valve is damaged, remove the mains plug immediately.
• A water inlet hose with safety valve must only be replaced by a specialist or by the Service
Warning! Dangerous voltage.
Water outlet hose connection
The drain hose can face either to the right or left
of the dishwasher
Ensure the hose is not bent or squashed as this
could prevent or slow down the discharge of
The sink plug must not be in place when the ma-
chine is draining as this could cause the water to
syphon back into the machine.
When connecting the drain hose to an under sink trap spigot, the entire plastic membrane
(A) must be removed. Failure to remove all the membrane will result in food particles
building up over time eventually blocking the dishwasher drain hose spigot.
Our appliances are supplied with a security device to protect
against the return of dirty water back into the machine. If the
spigot of your sink has a "no return valve" incorporated this
can prevent the correct draining of your dishwasher. We
therefore advise you to remove it.
To avoid water leakage after installation make sure that the
water couplings are tight.