Cisco UCS C260 M2 User Manual page 19

Table 8 Available RAID Options (continued)
Product ID (PID)
RAID Configuration
R2XX-RAID0
R2XX-RAID1
R2XX-RAID5
R2XX-RAID6
R2XX-RAID10
.
Approved Configurations
(1) One or Two RAID Controller Cards
Choose one or two R2XX-PL003 LSI MegaRAID SAS 9261-8i RAID controllers listed in
■
You will be able to control from one to sixteen drives, depending on the drive bay(s)
selected and the type of installed transition card.
Caveats
If you choose one RAID controller card, it is installed in PCIe slot 3.
■
If you choose two RAID controller cards, they are installed in PCIe slots 3 and 5.
■
If you selected two drive bays with nonexpander transition cards, you will need two RAID
■
controllers to control the maximum number of drives (16). All other drive bay configurations
require only one RAID controller card to control the maximum number of drives that can be
installed in the drive bays.
You can choose an optional RAID configuration (RAID 0, 1, 5, 6, or 10), which is
■
pre-configured at the factory. If you do not choose a RAID configuration, the disks will be
configured as a JBOD.
Cisco UCS C260 M2 High-Performance Rack-Mount Server
PID Description
Factory pre-configured RAID striping option
Enable RAID 0 Setting. Requires a minimum of 1 hard drive.
Factory pre-configured RAID mirroring option
Enable RAID 1 Setting. Requires exactly 2 drives, with same size, speed, capacity.
Factory pre-configured RAID option
Enable RAID 5 Setting. Requires minimum 3 drives of same size, speed, capacity.
Factory pre-configured RAID option
Enable RAID 6 Setting. Requires minimum 4 drives of same size, speed, capacity.
Factory pre-configured RAID option
Enable RAID 10 Setting. Requires an even number of drives with a minimum of 4
drives of same size, speed, capacity.
NOTE: No RAID option can be chosen if you have one of the following configurations:
• A mix of SAS and SATA drives
• No drives
CONFIGURING the SERVER
Table 8.
19