Spark Plug - DAELIM S4 Owner's Manual

SPARK PLUG

If electrode is stained or clearance is not
right, satisfactory spark is not produced.
Clean and make adjustment.
●Remove the spark plug cap.
●Clean around the plug.
●Using a plug wrench, remove the plug.
SPARK PLUG
●Clean plug with plug cleaner.
●Check electrode for wear and corrosion.
If the ends become round, replace it
with a new one.
●Check the plug gap using a feeler
gauge.
PLUG GAP : 0.6~0.7mm
●Tighten with hands until the plug
washer touches cylinder head.
STANDARD PLUG : CR6HSA
●If new plug is installed, turn 1/2 and
tighten using a plug wrench.
(Torque : 14kgf.m)
●If plug is reused, turn 1/3~1/4 and
tighten.
CHECK GAP,
GAP
POLLUTION AND
SOOT
CHECK THE DAMAGE
CHECK CRACK
OF WASHER
<HANDLING FOR POOR STARTING>
During cold season or when frequent
short-distance traveling, the starting may
be poor and even the engine will be OFF.
This may be prevented by use of spark
plug. The spark plug of this vehicle is
equipped as standard when delivery.
However, the starting will be poor if the
vehicle is continuously driven under low
speed.
CAUTION
If plug of different maker or different
●
heat value is used, it causes
unsatisfactory engine starting,
inadequate engine revolution and
output deterioration.
After driving, the spark plug become
●
very hot. When inspecting, pay
attention not to be burned.
37