Bulb Replacement Method - DAELIM S4 Owner's Manual

<INSPECTION OF WINKER>
Turn a main switch "ON". Check the lamp
for proper operation (front/rear and
right/left) and sound by operating the
switch, and also a lens for damage or
contamination.
<INSPECTION OF STOP LAMP>
Turn a main switch "ON". Check a stop
lamp for proper operation by operating the
front wheel and the rear wheel brakes, and
also a lens for damage or contamination.

BULB REPLACEMENT METHOD

●Be sure to turn a main switch "OFF"
prior to replacement of a bulb.
●Use only a bulb of rated capacity.
●After replacement with new bulb, check
for proper operation.
CAUTION
Care is to be taken to avoid leaving
●
fingerprints on a headlight bulb.
Failing to observe this may cause
early damage of the headlight bulb
resulted from concentration of heat.
Be sure to wear clean gloves when
●
replacing a bulb. If touched to it with
bare hands, clean it with a cloth
soaked with alcohol to prevent from
early damage.
<HEADLIGHT LAMP>
(1) Loosen 4 washer screws and remove
the headlight.
(2) Press the socket spring, turn counter
clockwise.
(3) Remove the headlight bulb.
(4) Replace the bulb with new one install
in the reverse order of removal.
HEADLIGHT BULB : 12V 35/35W
HEADLIGHT BULB
SOCKET
HEADLIGHT ASS' Y
27