DAELIM S4 Owner's Manual page 37

Check the oil level gauge, and add the engine
oil until it reaches the specified level.
(Between max and min)
UNDER THE ENGINE
OIL FILTER SCREEN
SPRING
OIL DRAIN CAP
[WHEN REPLACING THE OIL DRAIN BOLT]
1. Stop the engine, place a vessel under
the engine, remove the oil drain bolt,
and drain the oil.
2. Clean the oil drain bolt washer.
3. Install the oil drain bolt washer.
●When refilling the oil, open the oil filter
cap and refill untill the specified level..
WASHER
OIL DRAIN BOLT
[THE ENGINE OIL CAPACITY]
FULL CAPACITY
WHEN CHANGING
ℓ
[SPECIFIED GENUINE OIL]
Don't fill the low grade oil. Using it can
cause damage to engine, and can't receive
the warranty. Use only the genuine oil.
Genuine oil: Motics 4 oil
SD grade (SAE : 10W30#)
WARNING
If changing the oil by loosening the oil
●
drain bolt, always clean the oil filter
screen.
LEFT THE ENGINE
When changing the engine oil
●
immediately after stopping the engine,
be careful not to be burned the hot oil.
When refueling, make sure not to enter
●
the dirt into oil pouring port.
If the oil overflows, wipe it clearly.
●
Do not fill the oil past the level plate. It
●
can cause damage to engine.
Don't fill the low grade oil. Using it can
ℓ
●
cause damage to engine and parts. If the
engine is stuck while traveling due to
this, it may lead death or serious injury.
Use only the genuine oil.
Do not pour the 2 cycle engine oil.
●
Using it can cause serious damage to
engine. If the engine is stuck while
traveling due to this, it may lead death
or serious injury.
If the tire is stained with oil while or
●
after refueling, the vehicle may slip
while traveling to cause roll over.
Do not discard the engine oil other
●
than specified place. It will bring
environmental contamination, and be
brought under the law.
35