What To Do If - AEG BE5003001 User Manual

Removing and cleaning the door glass panels
1. Remove the oven door.
2. Hold the door t (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
3. Pull the door t to the front to remove it.
4. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.

WHAT TO DO IF...

WARNING!
Refer to "Safety information" chapter.
Problem
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven lamp does not oper-
ate
Possible cause
The appliance is switched off
The clock is not set
The necessary settings are not
set
The automatic cut-out is
switched on
The fuse is released
The oven lamp is defective
What to do if...
B
Solution
Switch on the appliance
Set the clock. Refer to "Setting
the clock"
Make sure, the settings are cor-
rect
Refer to „Automatic cut-out"
Make sure, if the fuse is the
cause for the malfunction. If
the fuse releases again and
again, refer to an authorized
electrician
Replace the oven lamp.
27