B-52 Instruction And User's Manual page 29

/ RELOOP buttons will begin flashing, indicating the
LOOP edit mode is activated, and character display on
the top of your LCD display will show your precise
OUT point position in minutes, seconds and frames.
You can then precisely edit the OUT point with the JOG
WHEEL frame-by-frame. Your loop will change on-the-
fly. To exit the edit mode, simply press the OUT or
RELOOP buttons.
MEMORY BANKS ADVANcED OPERATION:
Your Prodigy is
equipped with an inde-
pendent 3-bank memory
on each side for storing CUE points.
---- To memorize CUE points press the MEMORY button
and it will light red. Then press any of the 1-3 memory
banks buttons. It will flash red, indicating that a new
CUE point was memorized. The MEMORY button light
will turn off. To memorize another CUE point press
the MEMORY button again to activate it, then press
another memory bank button. The new memory bank
button will flash and the previously memorized
memory bank button will turn solid red to indicate
it is available for recall.
---- To recall any of the memorized CUE points, press
the corresponding button, which will light solid red.
Your music will jump to the corresponding CUE point
and will start playing immediately.
• TIP: You can preview a CUE point from any active
bank when a CD is in PAUSE mode. To do this,
press and hold one of the active memory bank
buttons. The music will be playing while you are
holding this button and will jump back to the CUE
point and pause once you release this button.
----- YOU can memorize a complete seamless loop as a
CUE point in a memory bank.
---- TO place a seamless loop into memory, you have
to set up a seamless loop first, as described above. You
PreCision for your PAssion
must then activate the memory banks by pressing the
MEMORY button, which will turn red. Then press the
memory bank button where you want to store your loop
and it will flash red. Now you can recall your seamless
loop at any time from the memory banks.
---- CUE points memorized in the three memory banks
can be placed in permanent memory using the
MEMORIZATION procedure. They will be kept in the
Prodigy's memory even after the CD is ejected and the
unit is turned off. They can be recalled at any time us-
ing the RECALL procedure for up to 500 CDs.
To place previously set CUE points into permanent
memory, press and hold the MEMORY button for 2
seconds. You will see SAVING on display. You can now
eject your CD, put in a new CD and memorize new
CUE points on the new CD. If you want to recall CUE
points from the first CD, press the MEMORY button mo-
mentarily (don't hold it) just before putting this CD into
CD slot. You will see RECALL on the display and your
previously memorized CUE points will be active and lit.
SCRATCH DSP effect: This effect emulates real time
turn- table scratching on a vinyl record player. Scratch
effect has dual mode of operation: normal SCRATCH
and SCRATCH CUE.
To activate the nor-
mal mode, press the
SCRATCH effect but-
ton momentarily and
the button will light
solid green.
You can now use the
scratch technique on
your CD.
To activate the
SCRATCH CUE mode,
press and hold the
SCRATCH button for a
second and the button
will flash green. Now
when you touch the
JOG WHEEL while your CD is playing, your CD will
jump to the CUE point and you can scratch around it.
In the PAUSE mode, when you touch the JOG WHEEL
after pressing the CUE button, the CD will play until you
B-52 Professional Prodig y - Instruction Manual
continued next Page
29