Rear Panel Controls And Connectors - B-52 Instruction And User's Manual

REAR PANEL CONTROLS & CONNECTIONS
1. POWER SWITcH: Turns the unit on and off.
2. Ac cONNEcTION: Plug the power cable in here.
3. Ac VOLTAGE SELEcTOR: 115Vac and 230Vac
switch. Your Prodigy unit ships with the AC VOLTAGE
SELECTOR switch set for your country's AC line voltage
and with the appropriate power cord. If you moved
your Prodigy to another country, make sure to set
the proper AC line voltage using the VOLTAGE
SELECTOR switch. Use a powercord approved for
your new location.
4. MASTER xLR OUTPUT JAcKS: Connect to balanced
inputs of your B-52 Matrix system or to any power
amplifier using balanced cables with XLR connectors.
• NOTE: Your Prodigy comes with rubber plugs
inserted into the MASTER OUTPUT XLR connectors.
Always insert / replace these rubber plug when
the XLR cables are not connected. Do not perma-
nently remove these rubber plugs from the unit.
5. MASTER UNBALANcED RcA OUTPUT JAcKS:
Connect to unbalanced inputs of your mixer or ampli-
fier using audio cables with RCA connectors.
6. BOOTH OUTPUT JAcKS: Connect to inputs of your
active monitors using cables with RCA connectors.
PreCision for your PAssion
7. REc OUTPUT JAcKS: Connect to the inputs of your
recorder using audio cables with RCA connectors.
These outputs provide the same signal as MASTER
OUTPUTs, but they are not influenced by the master
volume, master balance and MONO/STEREO switch.
8. cD DIREcT OUTPUT JAcKS: These are analog
outputs from the left and right CD players. You can con-
nect them to the external mixer or amplifier.
• NOTE: You can use these outputs to connect
your unit to SERATO™, TORQ™ or similar
systems with time-coded CDs. If you connect these
outputs to SERATO™ or TORQ™ then you must
connect the analog outputs of SERATO™ or
TORQ™ to LINE1 and LINE2 inputs and switch
channels 1 and 2 to LINE1 and LINE2 inputs
respectively. You then can use the Prodigy FX CD
players to control SERATO™ or TORQ™.
• TIP: If you are playing a time-coded CD for
SERATO™ or TORQ™, don't switch channels
1 and 2 to CD1 and CD2 positions, they will not
play properly.
9. EFFEcTS LOOP / SEND (OUTPUT): Connect to
B-52 Professional Prodig y - Instruction Manual
continued next Page
25