B-52 Instruction And User's Manual page 26

REAR PANEL CONTROLS
From previous page
the input terminal of the external effects processor.
10. EFFEcTS LOOP / RETURN (INPUT): Connect to
the output terminal of the external effects processor.
• NOTE: Your Prodigy comes with wire
jumpers inserted between left and right
channels' SEND/RETURN connectors. If
external effect processor is off or is not
connected to the rear panel and supplied
jumpers are removed from SEND/RETURN
connectors for an external processor, the signal
will mute on the channels on which FX LOOP
knobs are activated, as signal path is open.
Make sure to keep these jumpers and insert
them into the EXTERNAL EFFECTS' SEND /
RETURN connectors when you are not using
an external processor.
11. MP3: Connect this 3.5mm mini Jack to the out-
26
B-52 Professional Prodig y - Instruction Manual
PreCision for your PAssion
puts of your MP3 player (or other similar stereo
source) using audio cables with 3.5mm plugs.
12. PHONO INPUT JAcKS: Connect to the outputs of
your vinyl turntables with phono (RIAA) stage using
magnetic (MM) cartridge.
13. LINE INPUT JAcKS: Connect to the outputs of
your line-level signal sources using audio cables with
RCA connectors.
14. PHONO GROUND ScREW: Connect the ground
wire from a turntable to these terminals when using
vinyl turntable signal sources. This will help in elimi-
nating hum and buzz.
• NOTE: It is not a safety earth ground terminal.
15. MIc cOMBO INPUT (for MIc2): Use to connect
microphone with either an XLR or 1/4" TRS Jack con-
nector to CH-4 input.