Inserting Memory Card; Ejecting Memory Card - Becker TRAFFIC ASSIST Operating Instructions Manual

Notes:
A small slider is located on one side of the
card.
The card slot is located on the right side of
the unit. The card compartment is
equipped with a spring-actuated lock and
ejection mechanism.
Notes:
The memory card should only ever be in-
serted and ejected when the unit is
switched off. If the unit is not switched
off, data may be lost.
Navigational operations are not possible if
the memory card containing card data is
not inserted. If you remove this during
navigation, directions to your destination
will be aborted immediately.

Inserting memory card

> Remove the memory card from its
packaging without touching or soiling
the contact bar.
> Hold the memory card such that the
contact bar faces towards the rear of the
unit.
> Guide the memory card into the card
slot.
> Exert a little pressure and slide the
memory card into the card slot until it
snaps in.

Ejecting memory card

The card slot ejects the card so that you
can pull it out with two fingers.
> Use your finger to gently press the
memory card against the spring force
into the card slot and then release it.
The card is ejected.
> Remove the memory card and place it
in the packaging while ensuring not to
touch contact bar.
>>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
19