Using The Map Display; Repeating The Last Announcement; Changing The Announcement Volume - Becker READY 50 Operating Manual

>>> NAVIGATION MODE
Note:
> D
The tunnel view provides a schematic
view of the route layout of the tunnel.
> GB
The whole tunnel layout, the first route
> F
section and the vehicle position are
displayed. Since there is no GPS signal
> I
during the travel through the tunnel, the
> PL displayed position is only calculated.
82

Using the map display

Repeating the last announcement

During route guidance, the system
announces important information, e.g.
the next driving manoeuvre. The last
announcement can be repeated with
updated information.
> Press the speaker symbol in the
preview area while route guidance is
active.
The last announcement is be repeated
with updated information. The volume is
also displayed. If the preview area is
reduced and no speaker symbol is
displayed, the announcement can be
spoken again if you press the preview
area.

Changing the announcement volume

The volume of announcements can be
adjusted.
> Press the speaker symbol in the
preview area while route guidance is
active. On the top edge of the image,
the Mute button is displayed with a
speaker symbol. A bar diagram and
the and buttons are
displayed on the right.
The bar diagram represents the volume.
> Press
or or pull your finger
over the scroll strip to increase or
decrease the volume.
> Press
Mute
in order to mute the
announcements.