Coolant Temperature Gauge - Yamaha TDM900 Owner's Manual

cC
Do not operate the engine in the
tachometer red zone.
Red zone: 8,000 r/min and above
This tachometer unit is equipped with
a clock.
To set the clock:
1. Push both the "SELECT" and
"RESET" buttons for at least two
seconds.
2. When the hour digits start flash-
ing, push the "RESET" button to
set the hours.
3. Push the "SELECT" button to
change the minutes.
4. When the minute digits start
flashing, push the "RESET" but-
ton to set the minutes.
5. Push the "SELECT" button to
start the clock.
INSTRUMENT AND CONTROL FUNCTIONS
EC000003
NOTE:
8 After setting the clock, be sure to
push the
before turning the key to "OFF",
otherwise the clock will not be
set.
8 When the key is turned to "OFF",
the clock display will remain on
for 48 hours and then go off to
prevent the battery from dis-
charging.
"SELECT" button

1. Coolant temperature gauge

2. Coolant temperature red zone
Coolant temperature gauge
Cool a nt t e mper a t u r e gauge
With the key in the "ON" position, the
coolant temperature gauge indicates
the temperature of the coolant. When
the key is turned to "ON", the coolant
temperature gauge needle will move
to "H" and back to "C" in order to test
the electrical circuit. The coolant tem-
perature varies with changes in the
weather and engine load. If the nee-
dle reaches or enters the red zone,
stop the motorcycle and let the
engine cool. (See page 6-45 for fur-
ther instructions.)
3-6
3
EAU04939