Coolant Temperature Gauge - Yamaha TDM TWIN 900 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
This tachometer unit is equipped with a
clock.
To set the clock:
1. Push both the "SELECT" and "RE-
1 SET" buttons for at least two sec-
onds.
2. When the hour digits start flashing,
2
push the "RESET" button to set the
hours.
3
3. Push the "SELECT" button to
change the minutes.
4. When the minute digits start flash-
4
ing, push the "RESET" button to
set the minutes.
5
5. Push the "SELECT" button to start
the clock.
6
NOTE:
G
After setting the clock, be sure to
7
push the "SELECT" button before
turning the key to "OFF", otherwise
the clock will not be set.
8
G
When the key is turned to "OFF",
the clock display will remain on for
9
48 hours and then go off to prevent
the battery from discharging.

Coolant temperature gauge

2
1
1. Coolant temperature gauge
2. Coolant temperature gauge red zone
With the key in the "ON" position, the
coolant temperature gauge indicates
the temperature of the coolant. When
the key is turned to "ON", the coolant
temperature gauge needle will sweep
once across the temperature range and
then return to "C" in order to test the
electrical circuit. The coolant tempera-
ture varies with changes in the weather
and engine load. If the needle reaches
or enters the red zone, stop the vehicle
and let the engine
page 6-33.)
3-6
EAU12181
CAUTION:
Do not operate the engine if it is
overheated.
cool. (See
ECA10020