Fitting A Vtr; Using The Camcorder Grip - Sony DXC-D35 Service Manual

Fitting a VTR

4
Slide the DSR-1/1P and the
camera head together in the
groove as far as possible.
5
Tighten the two screws in the
grip connector and the two
screws in the shoulder pad
section.
6
Attach the shoulder pad.
To remove the VTR
Reverse the fitting procedure.
26
Chapter 2 Fitting and Connections
Screws
To fit a camera adaptor
Follow the same procedure as when fitting a VTR.

Using the Camcorder Grip

When using the camera head with a VTR as a
camcorder, you can replace the camera head's grip
with a camcorder grip (not supplied). The type of
Attaching a camcorder grip to the DSR-1/1P
1
If the viewfinder is attached,
adjust the viewfinder to the
full-forward position.
For details, see "Adjusting the
viewfinder position" on page 32.
2
Remove the camera head
grip's three screws, then pull
up the grip to remove it.
3
Remove the VTR connection
plate.
4
Remove the DSR-1/1P's
shoulder strap fitting and the
camera head connection plate.
Camera head
connection plate
Shoulder strap
fitting
camcorder grip and the method for attaching it differ
slightly depending on the type of VTR.
VTR connection
plate
(continued)
27
Chapter 2 Fitting and Connections