Image Adjustment - Christie DHD800 User Manual

Chapter 4 Controlling the Projector

Image adjustment

This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store button, and to load the adjusted value, click Load button.
Item
Contrast .............................. Adjusts picture con-
Brightness ......................... Adjusts picture bright-
Color ...................................... Adjusts picture color
Tint ......................................... Adjusts picture hue.
BrilliantColor ................... Applies improved
Color temp. ....................... Sets a color temperature
White Balance
Red, Green, Blue ..... Adjusts each white
* When Color matching is set to
"On" and changing the "Target"
value of "Advanced color match-
ing", the color temp. indicates
"Adj."
Offset
Red, Green, Blue ..... Adjusts each offset
Sharpness ................................ Adjusts picture sharpness. (0~ 31)
Gamma .......................................... Adjusts brightness of darker part of the picture. (0~ 15)
Noise reduction ................ Switches noise reduction mode (ON, OFF)
Progressive ............................ Switches progressive mode (ON, OFF, Film)
Reset............................................Resets the Image adjustment to previous levels.
Store ............................................ Stores the Image adjustment values. Select an item [Image1 - Image10]
Load image mode ............. Loads the Image mode. Select an image mode from the pull-down menu
Input source
Image mode Video Computer
Standard
Cinema
Real
Dynamic
Image1 - 10
36
Description
trast. (0~ 63)
ness. (0~ 63)
saturation. (0~ 63)
(0~ 63)
color performance
with the BrilliantColor™
technology. (ON, OFF)
mode. (XLow, Low, Mid,
High, Adj.)
balance respectively.
(0~ 63)
respectively. (0~ 63)
from the pull-down menu and click Store button.
and click Load button. There may not be available mode depending on the
input mode as shown in the table left.
*
*
The mark " " means that the available image mode in the
selected input source. The error message appears when
selecting the disabled image mode indicated with "*".
DHD800 Network User Manual
020-000246-01 Rev.1 (08-2010)