Billion BiPAC 7401VGP R3 User Manual page 98

Packet Filter – Add Raw IP Filter
Go to "Type" drop-down menu, select "Use Protocol Number".
Rule Name Helper: User defined description for entry identification. You may also choose from
the Select drop-down menu for an existing predefined rule.
Time Schedule: A self defined time period. You may specify a time schedule for your
prioritization policy. For setup and detail, refer to Time Schedule section.
Source IP Address(es) / Destination IP Address(es): This is the Address-Filter used to allow or
block traffic to/from particular IP address(es). Select the Subnet Mask of the IP address range you
wish to allow/block the traffic to or form; set IP address and Subnet Mask to 0.0.0.0 to inactive the
Address-Filter rule.
Tip: To block access to/from a single IP address, enter that IP address as the Host IP
Address and use a Host Subnet Mask of "255.255.255.255".
Type: It is the packet protocol type used by the application, select TCP, UDP or both TCP/UDP.
Protocol Number: Insert the port number, i.e. GRE 47.
Source Port: This Port or Port Ranges defines the port allowed to be used by the Remote/WAN to
connect to the application. Default is set from range 0 ~ 65535. It is recommended that this option
be configured by an advanced user.
Destination Port: This is the Port or Port Ranges that defines the application.
Inbound / Outbound: Select Allow or Block the access to the Internet ("Outbound") or from the
Internet ("Inbound").
When all changes is made, click Add button to apply your changes.
91